Before bringing the board into the water, you can test the jetpack on land to make sure everything is working properly.

First, pair the hand controller by connecting the magnet key of the board leash into its fitting on the back of the board.

Then, press the controller throttle all the way down for up to 5 seconds until the LED lights begin to flash.

When the lights go from flashing to steady, the controller is paired with the board. Continue to apply pressure to the throttle. When you do this, you should hear the hum of the jetpack start.

During the dry test, the jetpack will not go into full capacity since it can’t be cooled off by the water. When the board is in water, the jetpack will go into full capacity.